Our Products

Rotary Evaporator

Laboratory equipment

Jacketed Reactor

Contact Us

european-fuel-cell-forum-2011

European Fuel Cell Forum 2011

Full text of "A Handbook of the Petroleum Industry"

An illustration of two cells of a film strip. Video. An illustration of an audio speaker. Audio. An illustration of a 3.5" floppy disk. Software. An illustration of two photographs. Images. An illustration of a heart shape Donate. An illustration of text ellipses. More. An icon used to represent a menu that can be toggled by interacting with .

Courses of Study 2008

COURSES OF STUDY 2008 Indian Institute of Technology Kanpur KANPUR - 208 016 (i) BOARD OF GOVERNORS M. Anandakrishnan Chairman Dhande, S.G. Director Rajendra Govind Harshe D. V. Singh Inder Kumar Khosla

Report - IIT Bombay [PDF] - Free Online Publishing

Transcript. 1 Introduction Larger number of courses are being made available in video and other modes; and attempts have been made I am pleased to share that Indian Institute of to employ Flipped Classrooms and Peer based Technology Bombay (IIT Bombay) continues to be learning, at the Institute. ranked as one of the top universities of the Country IIT Bombay continues to be the most sought .

Annual Report 2010-11 - Indian Institute of Technology .

Senthil Kumar, Mani & Kumaraswamy analysed numerically and experimentally ejectors for use as vacuum pump in a desalination system. They built and demonstrated a experimental flash evaporation desalination system operating with ocean temperature gradient (simulated heat sources ).

committees-eth-zurich

committees - ETH Zürich

microelectromechanical systems based: Topics by Science.gov

2018-6-5 · High-temperature microelectromechanical pressure sensors based on a SOI heterostructure for an electronic automatic aircraft engine control system. NASA Astrophysics Data System (ADS) Sokolov, Leonid V. 2010-08-01. There is a need of measuring distributed pressure on the aircraft engine inlet with high precision within a wide operating temperature range in the severe environment to .

microelectromechanical systems based: Topics by Science.gov

2018-6-5 · High-temperature microelectromechanical pressure sensors based on a SOI heterostructure for an electronic automatic aircraft engine control system. NASA Astrophysics Data System (ADS) Sokolov, Leonid V. 2010-08-01. There is a need of measuring distributed pressure on the aircraft engine inlet with high precision within a wide operating temperature range in the severe environment to .

Annual Report 2010-11 - Indian Institute of Technology .

Senthil Kumar, Mani & Kumaraswamy analysed numerically and experimentally ejectors for use as vacuum pump in a desalination system. They built and demonstrated a experimental flash evaporation desalination system operating with ocean temperature gradient (simulated heat sources ).

metal evaporator

Evaporation (deposition) - Wikipedia. The K975X is a compact, bench-mounted, multiple application thermal evaporator for vacuum deposition of thin layers of carbon and metals. It is ideal for a wide range of techniques, including the production of carbon support films and replicas for TEM and carbon/metal thin film applications.

Thermal Evaporation (Thin-film Deposition) system

Thermal Evaporation (Thin-film Deposition) system. The Thermal Evaporator system purchased from Consolidated Vacuum Corporation, New York, can deposit almost all metals onto various substrates by boiling the metal and evaporating it at high vacuum. The bell-jar connected to a diffusion vacuum pump gets evacuated to 1x10-6 mbar.

Facilities - IIT Kanpur

The system has been integrated to another Evaporation cum Sputtering system for fabricating the organic devices and then ransferring the same under <0.1ppm level to Encapsulation system. . [email protected] iitk.ac.in . PLE and Photoluminescence quantum efficiency (PLQE) for Organic and polymer luminescent materials of both solution and thin film .

UNAM

2008-4-27 · A refining process is needed for treating heavy petroleum fractions (atmospheric or vacuum oil residue) in the presence of catalysts and hydrogen at high pressure. In this article the different technologies for residua processing: thermal, catalytic fixed and ebullated types of hydroconversion are reviewed and discussed.

Facilities

Thin-filmThickness Measurement System. Thermal Cycler (PCR Machine . Thermal Evaporation (Thin-film Deposition) system . Transportation Engineering Laboratory. UV-Vis Spectrophotometer. . UV-vis NIR spectrophotometer with in-situ capabilities. Vacuum Induction Melting Unit. Vacuum annealing system [up to 10000C] Vector Network Analyzer Facility.

75470033 Mechanical Engineering [zg0rpd257wlk]

Smaller air handlers may contain a fuel-burning heater or a refrigeration evaporator, placed directly in the air stream. . • Evaporative: dry air blown over a reservoir will evaporate some of the water. The rate of evaporation can be increased by spraying the water onto baffles in the air stream. . models and measurements, 2006, 71-83 [12 .

Courses of Study 2008 IITK Kanpur

IITK courses of study in the year 2008. (i) COURSES OF STUDY 2008 Indian Institute of Technology Kanpur KANPUR - 208 016

custom-made 0 5l thermal evaporator system for africa

Donald M. Mattox, in The Foundations of Vacuum Coating Technology, 2003. Thermal evaporation was an obvious vapor source long before it was studied. Its development was inhibited by the high radiant-heat loads and the lack of vacuum materials and techniques that could withstand the heat, particularly in a demountable system.

SRM University

2019-7-25 · A high vacuum of 1 x 10-6 m.bar can be maintained within the furnace chamber. E-Beam evaporation; Physical Vapor Deposition System with 4-Source E Beam evaporator, thermal evaporator, in-situ Argon Ion Etching and Annealing. Pumping System; Varian's Turbo Molecular Pump with a pumping capacity of 550l/sec; Advanced Thin Film Controller

european-fuel-cell-forum-2011

European Fuel Cell Forum 2011

vapor pressure equilibrium: Topics by Science.gov

Evaporation rate and vapor pressure of selected polymeric lubricating oils. NASA Technical Reports Server (NTRS) Gardos, M. N. 1973-01-01. A recently developed ultrahigh-vacuum quartz spring mass sorption microbalance has been utilized to measure the evaporation rates of several low-volatility polymeric lubricating oils at various temperatures.

Calaméo - Etcme 14

2020-5-28 · The typical flat-plate modules achieve Efficiencies between 10 – 15%. Solar cells and their corresponding modules can be divided into two main categories: wafer-type solar cells and Thin-film solar cells. • Solar thermal-electric is used to produce hightemperature heat, which is converted into electricity.

Total Ideas - MHRD | MHRD Innovation Cell

The huge man power required for cotton plucking and the amount of money that it takes for the farmer to hire the workers can be reduced on drastic level by the arm robot.The arm robot uses certain degree of freedom to pluck the cotton only and not the branches.Basically using image processing the position of cotton is identified using two cameras one at the left and one at the right.

Thermal Evaporation (Thin-film Deposition) system

Thermal Evaporation (Thin-film Deposition) system. The Thermal Evaporator system purchased from Consolidated Vacuum Corporation, New York, can deposit almost all metals onto various substrates by boiling the metal and evaporating it at high vacuum. The bell-jar connected to a diffusion vacuum pump gets evacuated to 1x10-6 mbar.

Full text of "Official gazette of the United States Patent .

NASA Images Solar System Collection Ames Research Center. Brooklyn Museum. Full text of "Official gazette of the United States Patent and Trademark Office: [microform]"

laboratory thermal evaporator

Desk Thermal Evaporator | turbomolecular-pumped - VacCoat. Triple Source Desk Thermal Evaporator (DTT) The DTT is a desktop, a turbomolecular-pumped thermal evaporator for vacuum deposition of thin films. The triple-source evaporation with evaporation source (boat/basket / coil) selection system is ideal for deposition of multilayers or alloys.

Report - IIT Bombay [PDF] - Free Online Publishing

Transcript. 1 Introduction Larger number of courses are being made available in video and other modes; and attempts have been made I am pleased to share that Indian Institute of to employ Flipped Classrooms and Peer based Technology Bombay (IIT Bombay) continues to be learning, at the Institute. ranked as one of the top universities of the Country IIT Bombay continues to be the most sought .

Calaméo - Etcme 14

2020-5-28 · The typical flat-plate modules achieve Efficiencies between 10 – 15%. Solar cells and their corresponding modules can be divided into two main categories: wafer-type solar cells and Thin-film solar cells. • Solar thermal-electric is used to produce hightemperature heat, which is converted into electricity.

UNAM

2008-4-27 · A refining process is needed for treating heavy petroleum fractions (atmospheric or vacuum oil residue) in the presence of catalysts and hydrogen at high pressure. In this article the different technologies for residua processing: thermal, catalytic fixed and ebullated types of hydroconversion are reviewed and discussed.

Full text of "A Handbook of the Petroleum Industry"

An illustration of two cells of a film strip. Video. An illustration of an audio speaker. Audio. An illustration of a 3.5" floppy disk. Software. An illustration of two photographs. Images. An illustration of a heart shape Donate. An illustration of text ellipses. More. An icon used to represent a menu that can be toggled by interacting with .

A novel method for metal oxide deposition on carbon .

The carbon film electrode was fabricated by electrophoretic deposition. Micro-Raman spectroscopy revealed the highly increased disorder of sp ² C lattice for the AC treated at 75 W.